I wanted something a little lighter, so now our bedroom is looking completely different (reveal coming soon!) But first, here's our original headboard.
If you're looking for a quick and easy DIY headboard, this is it! It's SUPER simple! You can easily be done in just a few hours!
To get started, you will need:
Materials:
Plywood (3/8" to 1/2") cut to size 60" wide for a queen bed (height is variable, but about 3' - make sure that the plywood goes behind the mattress)
2x2 (qty 4)
Foam (bed topper, from Target, Wal-Mart etc. - smooth side out - size full or Joanns, Hobby Lobby, etc.)
2 yards of fabric (I used this) Since home decor fabrics are typically 54" wide - for a queen bed and larger, you will need to railroad the fabric - so run the pattern the opposite direction as shown online. If you're using a print, make sure that it looks good running the opposite direction.
Batting (size full)
Cardboard upholstery strip
Tools:
Drill
Saw - chop saw or jigsaw to cut the 2x2s (most home improvement stores will cut the plywood to size)
Scissors
Screws (1.25")
Staple gun
Cut the 2x2s to size and frame the back of the plywood.
From the front - pre drill holes and secure the plywood to the 2x2s using 1.25" screws.
Here are our cuts - image below shows back of headboard:
Plywood 36" x 60"
2x2s (sides) 56"(x2)
2x2s (top and bottom of plywood) 57" (Note: 2x2s actually measure 1.5", so 1.5"+1.5"+57" = 60")
Next, we cut the foam to size (we used an egg crate mattress topper - it was the cheapest way that we found to cover the entire surface without seams)
Cut the foam 1" larger than your plywood back (ours measured 37" x 61") you want the foam to crush around the edges for a more finished look. Secure the batting to the plywood with spray adhesive (liquid glue - thinly spread will work too) (this will make upholstering easier so it doesn't move around) Attach the foam, smooth side up.
Cut a piece of batting to size - a few inches larger on each side. Note: if you have seams in your foam, apply an extra layer of batting to help conceal the seam.
Cut your fabric to size - slightly larger than the batting. Tip: place the headboard on boxes or whatever you have on hand to lift it off the ground slightly
Secure the fabric. For a more finished look, we applied the fabric in two steps. The first is stapled about half way down the 2x2 (it will be visible from the sides, but it will be covered in the next step.)
We like to apply a few staples on the top and bottom - pulling tight as we go - alternating top and bottom (apply about 10 staples at a time) - then we repeat with the sides.
Here's a close - up of the corner.
Next, finish the edges. To get a super crisp line, we used a cardboard upholstery strip underneath the fabric.
First, we placed a strip of tape along the edge of plywood to keep a guideline.
We cut a strip of fabric to go across the top (about 66" x 5") Using the guideline, we secured the fabric in place. We like to cut our fabric a little large - it's easier to work with and you can always trim the excess off.
Lining the cardboard strip with the tape guideline, we stapled in place.
We repeat for the sides. And folded the fabric at the corners.
Then, we flipped the headboard over and secured the side pieces on the back with staples.
To finish the legs, we wrapped them with fabric and stapled on the back. The headboard was attached to the bed by measuring the holes on the frame and drilling two holes (trim fabric where drilling so it doesn't catch) - bolts and nuts secure the headboard to the frame.
That's it!
This headboard can easily be done in an afternoon or evening!
Wrapping the fabric around the cardboard strip gives it a super crisp edge.
Duvet is from Crate and Barrel (Marimekko a few years ago) Lumbar pillow is from Marshalls. Sheets and coverlet are from TJ Maxx. Euro shams are from Target.
Approximated total cost:
Plywood: $13
2x2s (qty 4): $8
Fabric (2 yards): $60
Foam: $15
Batting: $10
Total: $106
The fabric made this a little pricier, but it could easily be done for under $100 if you save on fabric. (Check out the clearance section of Home Goods, TJ Maxx, etc. for tablecloths, typically, you can find enough fabric for under $20!) So you could make it for about $60!
If you're looking for a super simple headboard, this is it!! SO easy!
P.S. This headboard (and lots of other things) will be included in a moving sale that we'll be having in a few months. If you're in east TN and would like to be first on the list for an item, let me know - you can email me at sarahmdorseydesigns@gmail dot com (dot added in place of . to reduce spam)
0 comments:
Post a Comment